Email:wfn100@wolfni.com
emma@wolfni.com
phoebe@wolfni.com
Ailsa@wolfni.com
Tel:+86 28 84812280
Fax:+86 28 84833319
QQ:494800536
Skype:emma.wolfni
wolfni06
wolfni07
WeChat:13982068792
Address:About 30 minutes to Chengdu International Airport
Tricone Bits
6 1/2in IADC 437 (165.1mm)
IADC:437
ID:165.1
Design Specifications
IADC Code 437
Type TCI
Number of cones 3
Number of nozzles 3
Bearing type Rubber
Seal type Slide
Center water hole NO
Tooth shape Wedge
Thread Connection 3 1/2" API REG Pin
Type of reinforcement Alloy teeth
Weight 32Kg
package Wooden box
Operating Parameters
Bit Pressure: 0.4 ~ 0.65 KN
Rotary Speed: 60 ~ 200 r/min
Pumping Pressure: 10 ~ 20 Mpa
Sediment Concentration: < 0.5%

The above parameters are only for reference. Optimized parameters are determined by drilling process and lithology of formations on site.

Type IADC 437 tricone bits6 1/2inch  with 3 1/2 API REG PIN

type iadc 437 rock bits6 1_2  with 3 1_2 api reg pin-4

tricone bit nozzle and assembled size       

Bit  diameterNozzle outer diameterassembled lengthNozzle exit diameter (inner diameter)
inmmmmmmmm
3 1/2~5 1/288.9~139.720.317.54~10
5 5/8~7 3/8142.9~187.323.619.05~16
7 1/2~8 1/4190.5~209.629.821.07~18
8 3/8~14 5/8212.7~371.533.027.08~20
≥14 3/4≥374.640.927.010~22
Note: the assembled lenght is length from nozzle inlet to retaining ring groove

Applicable formations:

Hard-High compressive strength with sharp layers of sand or siltstone.Tricone bits will be used in rock drilling.

Sealed journal bearing

Journal bearing structure with head bearing hardfaced and cone bearing silver plated to improve load capacity and anti-galling ability of the bearing. More wear and high-temperature resistant highly saturated sealed journal bearing is used to improve reliability. Larger Sealed journal bearing reduces pressure on the seal, and the boss at outer end of the seal is also helpful for reliability of the seal.Surface of the thrust bearing couple are specially treated for decreasing friction and increasing rigidness, load capacity of the bit and anti-galling ability of the bearing are consequently improved.

Cutting structure

Hardfaced gage and tooth surfaces.

Hardfacing on shirttail

This feature can provide better protection for seal and bearing to extend the bit’s service life.

Email to this supplier

To: WOLFNI
*Name:
*Email Address:
*Message:
 

© 2017 Wolfni Limited. All rights reserved.   蜀ICP备11016153号                                   | Privacy | Terms | Help | Site Map | Contact |                                                                                            Share on FacebookShare on TwitterShare on LinkedInRSS